PLD880-G2 DIGITAL CONTROLLER
PLD880-G2 is a new generation digital controller for stepper motors, based on DSP. With this device, the parameters can be set via the USB port. It allows communication on such protocols as: STEP, DIR, ENABLE . All signal inputs are opto-isolated and compatible with logic levels: 2.5V, 3.3V, 5V. The use of the AUTO-SLEEP module allows for ergonomic management of the controller, it updates in the absence of STEP signal reading. The PLD 880 -G2 controller is the optimal choice when working with a series of stepper motors (uni- and bipolar) of the PL110 / PL130 series from Purelogic . However, the innovative approach has also enabled the control of engines from other brands.
The Purelogic controller has been equipped with the following systems:
-przeciwnapięciowe
-przeciwprądowe
-przeciwzwarciowe
- compensating for medium frequency resonance effects
- protecting against reverse electromagnetic field
-softstarter soft boot
- protective dummy
- STEP frequency generator, together with a system protecting against high frequencies at the STEP input.
Data:
- Power supply: 18 ... 80 [V]
- Stepper motor operating current: 2 ... 8 [A]
- Micro step split: 1 ... 512
- Max STEP signal frequency: 300 kHz
- Maximum speed: 3000 rev / min
- The rotational speed of the internal generator 0 ... 500 [r / min]
- ERROR output parameters: 50 V / max 50 mA
- Insulation resistance: 500 M?
- Ambient temperature: 0 ... 50 [° C]
Included:
-PLD880-G2 controller
-Instruction
Correct use of the controller before any changes and setting of connections will be ensured after switching off the power of the controlled system.
Do not connect the power supply terminal ? to ground, earth, etc.
The power switch must be installed before the power source, for ~ 220V.
Do not make serial connections, the "star" type is recommended.
Constant control of the correct polarity of the power and signal connections is required.
