PLCM-E1B CONTROLLER
PLCM-e1b controller controlling CNC devices via USB and Ethernet. The PLCM series is fully compatible with MACH3 software.
The USB connection to the computer must be made via a short, shielded cable with ferrite rings, only then it will allow to ensure a high level of resistance to external factors.
The controller has been equipped with short-circuit protection and protection against incorrect connection of the stepper motor.
Data:
- Compatible stepper motor driver protocols: STEP / DIR / ENABLE
- Interface: USB type B
- Compatibility: MACH3
- Max STEP signal frequency: 100 kHz
- Number of axles: 6
- Number of entries: 5
- Inputs: buffered
-Max input voltage: 15V CMOS
- Logical level of "0" inputs <1.8 V
- Logical level of inputs "1"> 2.5 V
- Number of outputs: 12
- Outputs: buffered
- Output voltage: 5 V
-Max output current: 10 mA
- Power supply: 12 V DC
- Maximum power consumption: 250 mA
- Insulation resistance: 500 M?
- Working temperature: 0 ... 50 [° C]
- Weight: 0.3 kg
- Dimensions: 83x27x66 [mm]
Included:
- PLCM-E1b controller
- Ethernet cable
- Instruction
Correct use of the controller before any changes and setting of connections will be ensured after switching off the power of the controlled system.
Do not connect the power supply terminal ? to ground, earth, etc.
We recommend using a high quality Ethernet cable (category 5 or higher).
The controller is compatible with version MACH3 R3.043.XXX or newer (upgrade recommended).
